3 of 3: Console table with drawers

Hi everyone. I’ve been making a console table in the workshop this week and how its made is quite distinct; this is how it went – enjoy!

This is Part 3 of 3

Part 1 here –  

Part 2 –

Please use the ‘Like’ button if you liked this video.

Please subscribe if you think you’d like to see more.

Support me directly on Patreon – www.patreon.com/10minuteworkshop

Full list of ‘Stuff I use’ at

Connect with me on twitter @10minuteshop

Connect with me on Instagram – 10minuteworkshop

Most links below are affiliate links; this means I may get a few pennies back if you buy something via these links, so if you do, thanks!

Used/featured in this video:-

Festool Domino – (US:

Festool Domino assortment – (US:

Festool Domino 5 x 30mm – (US:

Festool TS55 Tracksaw – (US:

Festool Kapex 120 – (US:

Festool ETS 150/5 – (US:

Festool Granat abrasive – (US:

Festool RTS 400 – (US:

Festool Granat abrasive – (US:

Festool Rotex 90 – (US:

Festool Granat abrasive – (US:

Festool lever clamp – (US:

Festool PDC 18/4 – (US:

Festool Midi extractor – (US:

Fevstool CTL Sys – (US:

Axminster trade clamp –

Braided hose sleeve – (US:

2-pack resin filler – (US[bondo]

Polyvine PolyTen PVA – (US:

Hultafors Talmeter tape measure – (US:

Spax screws – (US:

Spax MDF screws – (US:

Bahco 6” combi square – (US:

Bradawl – (US:

Photo/video gear

Main camera Panasonic Lumix G80 – (US – G85:

Olympus 12-40 f/2.8 – (US:

Second camera Panasonic FZ200 – (US:

Rode Videomic Pro – (US: